Transparent Hinged Cover Suits KAC Manual Call Points. Default sorting Sort by popularity Sort by latest Sort by price: low to high Sort by price: high to low. Showing all 12 results. Manual Call Point - Designing Buildings - Share your construction industry knowledge. Live investigations of false fire alarms, written by Raman Chagger and published by BRE in December 2015, defines a Manual Call Point (MCP) as: 'A component used in a fire detection and fire alarm systems that allows the user, when a fire condition is present, to manually trigger and activate the fire alarm The Norwegian norms state that the closest manual call point should be no more than 30 metres walking distance away from any point in the protected area. Although local regulations will apply, this is the minimum standard recommended by Autronica. Two main series are available: 300 series with SelfVerify, interactive addressable manual call points. The manual call point for indoor use. The call point is designed for use with Autronica's interactive fire detection systems, and comprises the SelfVerify function. This function ensures the highest grade of reliability and the lowest degree of manual testing as all units comprising this function are automatically self-tested once every 24 hours. amendments) of that Standard at the date of calling of tenders. The following table identifies Australian and International standards and other similar documents referenced in this document: Table 2 - Standards Referred to in this Technical Standard Standard Title AS 1603.5 Automatic Fire Detection and Alarm Systems - Manual Call Points Back to Products germantek technologies MODEL D-101 Demco Manual Call Point D-101 is suitable for open or close circuit system and is professionally designed for use in fire detection systems with central control equipment. Alternative terminals are provided for open or close circuits. When wired for open circuit operation, the circuit closes instantly when the glass is… Read More »Manual E2S Warning Signals manufacture an extensive range of manual call points, MCP, designed to be installed in hazardous areas, primarily for the control of fire and gas detection and alarm systems. They are available in different enclosure materials: STEx in 316L stainless steel for use in the harshest of environments, GNEx in anti-static, UV-stable corrosion proof GRP, and BEx in corrosion proof Federal Signal Manual Call Point Station may be field serviced with the Service/Accessory Kits specified within Table 2 on "Table 2 Call Points Field Installed Service/Accessory Kits" on page 23. Unpacking the Call Points Station After unpacking the station, examine it for damage that may have occurred in transit. If it has been damaged, do not The Weatherproof Conventional Manual Call Point ( WCP3A) is an IP67 sealed product. The enhanced environmental protection allows the unit to be installed in many external environments where water and dirt are likely to be present, making it a true weatherproof and outdoor product. The WCP3A product version is supplied with one normally open and Manual Call Point, Break Glass. This product has been replaced by theMCP5A-RP02SF-K013-01. Analogue Addressable manual call point ( MCP5A) is designed to provide a manual interface for raising an Alarm on the Fire Alarm System. The MCP5A communicates with the Fire Alarm Control Panel over a two-wire analogue addressable commu